炎炎夏日，抽沙船预防高温天气风采依旧

  夏天已经到来一段时间，伏天即将来临，都知道，伏天是整个夏天最热的日子，那么抽砂船的高温预防工作准备了吗？还是已经完成了。完成的话今天小编带您了解下抽沙船在启动前应注意的事项：
抽沙船有5项需要注意一下哦。
  启动前需要检查下各部位的螺丝有没有拧紧，是否牢固；电器设备是否可以可以正常使用。
  检查电源供电是否正常，检查抽沙船的指示器是否与实际相符。
  为了保护蓄电池和电机，应每次启动时间不超过十秒钟。如果启动时间过长或次数过多，需要检查原因排出故障。
  想要查看油泵运动件是否存在卡阻现象，需要用手转动油泵，需要检查的几项是，各系统的阀门，液压油，工作油，密封处的密封情况。
  启动后，抽沙船浮体的宽度和长度的尺寸是根据挖沙的深度来规定的，两个浮体之间要留有空间，是为了防止浮体之间不乱的原则。

Summer, hot weather is still pumping sand prevention style.
   Summer has come to a period of time, the summer is coming, all know, summer is the hottest summer days, then chousha boat high temperature prevention work ready? It's still finished. Pumping sand matters should be paid attention to in before the start of the finish today Xiaobian take you to understand:
Pumping sand 5 need attention oh.
   Before starting, it is necessary to check whether the screws in each part are tightened or not; whether the electrical equipment can be used properly.
  Check if the power supply is normal, check whether the indicator is consistent with the actual pumping sand.
   In order to protect the battery and motor, it should start at least ten seconds each time. If the boot time is too long or too many times, the cause must be checked out.
  Want to see whether the oil pump moving parts of the card phenomenon, the need to turn the oil pump by hand, the need to check a few items are the system valves, hydraulic oil, oil, sealing the sealing situation.
  After the start, pumping sand float width and length size is based on the depth of dredging requirements, to leave a space between the two floating bodies, in order to prevent the chaos principle between floating body.
   We have used in pumping sand, most do not want to see is the plugging phenomenon. Plugging will be time-consuming, artificial, need to clear the pipe before they can be used properly. We need to look at the concentration of sediment inside the tube sand, sand pumping pipeline distance we can not see with the naked eye, you need to install a pressure gauge in the pipeline, pumping sand concentration control through observation of pressure gauge.